2500W Induction Heater for ZVS Induction Heating Low Voltage Induction Heating Module 12V‑48V Flyback Drive Heater with Brass Ring

Specification:Item Type: Induction HeaterMaterial: PCB, BrassInput Voltage: 12V-48V, recommended above 36VPower Requirements: Below 12V, greater than or equal to 10AAbove 15V, greater than or equal to 20AFan: With a silent fanMaximum Power: 2500WMaximum Current: 50A1. The heating power is very high, except for the boards and components being very hot, the heating capacity of brass pipes is very high. Buyers can prepare a separate water cooling system by purchasing a small and a 2 meter rubber hose with an inner diameter of 4mm.2. When using switching power supplies, attention must be paid because high power switching power supplies generally have a function, and the output voltage rises slowly. If the Y voltage rises to 10V before, the circuit cannot withstand vibration due to insufficient voltage, causing two MOS transistors to conduct simultaneously and burn out components. Therefore, it is necessary to change the power supply voltage to stabilize, and then connect it to the heating circuit through induction.3. When heating metal objects, please do not heat too much metal, otherwise it may cause power overload. Please add a 35A or ammeter, and the air switch will be better. (Packaging not included)4. Although this drive board can withstand a current of over 40A, it is recommended not to exceed 48V 35A to avoid accidents and damage.packing list:1 x Induction Heater1 x Brass RingNote:1. The minimum input voltage of this module is 12V, which does not mean that all 12V power supplies can be used. Some novice buyers have used low power power supplies, and there are specific requirements for the voltage and current of this module. Only power supplies with a voltage of 12V and a current of 10A or above can be used. If the power supply is too low, it will result in a significant decrease in the actual output

• POWERFUL FUNCTION: The output end uses three M4 brass columns in parallel, which can be connected to other outputs such as high voltage packages; Using 6 IRFP260 and 12 parallel resonant capacitors, the heating board has high power and efficiency.
• WORK DETAILS: This induction heating circuit uses a 12‑48V low voltage DC power supply, with a maximum current of 50A and a maximum power of 2500W.
• FINE DESIGN: Induction heating board adopts a super large PCB layout design and a super large heat sink, which has good heat dissipation and high power. Comes with a cooling fan interface and can also be used for discharge, generator, high voltage inverter power supply, etc.
• EASY TO INSTALL : Compact size make the module easy to install on the equipment and machine, ideal replacement for the old and damaged parts.
• WIDELY APPLICABLE: Induction heater can work continuously under good heat dissipation conditions. Due to its moderate power, the module can be used by DIY players to perform heat treatment such as quenching and annealing on small parts. It can also be paired with a graphite crucible(without) to melt metals such as gold, silver, copper, aluminum, etc., heating evenly and quickly, making it very convenient.